Knife blocks have been a kitchen-counter fixture for many years, however the acquainted picket block additionally reveals the tradeoff: it claims a bit of labor floor for one job. Shifting knives onto the wall frees that spot whereas retaining every blade inside attain.
Homedit contributor Chelsea Mohrman took that concept in a much less anticipated course. Her model seems like a plain strip of walnut, with no steel rail, hooks, or knife slots seen from the room. Place a metal knife towards the wooden and the blade stays there.
The key sits behind the walnut. Recesses drilled into the again cease earlier than breaking by the entrance, leaving area for heavy-duty magnets that maintain the knife blades by the wooden.
Lacquer offers the walnut a sealed face
A 3/4-inch walnut board kinds the holder, lower to about 2.5 inches tall and eight inches lengthy for this undertaking. These dimensions can change primarily based on the quantity and measurement of knives.
Spray lacquer coats the uncovered face and protects the wooden. The grain stays seen, which helps the completed holder learn as a wooden accent slightly than kitchen {hardware}.
Holes cease earlier than reaching the entrance
Flip the walnut over and its hidden perform begins to make sense. A 3/4-inch Forstner bit creates two rows of recesses throughout the again.
Every gap reaches about 1/2 inch into the three/4-inch board. The drill should cease earlier than piercing the entrance, leaving sufficient wooden to hide what comes subsequent whereas retaining the magnets near the knives.
Magnets go contained in the drilled recesses
Tremendous glue goes into every opening earlier than spherical, heavy-duty magnets are inserted. The magnets must face the identical course as they fill the holes throughout the board.
As soon as set, the magnets keep out of sight behind the walnut. As a substitute of attaching knives to uncovered steel, magnetic power reaches every blade by the skinny wooden face.
Mounting {hardware} stays on the hidden facet
Small brackets connect to the again of the board close to every finish. Quick nails safe them to the walnut, whereas screws join the completed holder to the wall.
Each components that make the thought work now face the wall: the magnets maintain the knives and the brackets assist the board. From the kitchen, neither must be seen.
Knives seem to stay to stable wooden
As soon as mounted, the drilled recesses vanish from view. Three knives relaxation towards an unbroken strip of walnut with no seen clips or slots supporting their blades.
The tactic does depend upon the knife. Ceramic blades won’t connect to a magnetic holder, and a few stainless-steel knives could produce a weak magnetic maintain.
Counter area stays open beneath the knives
Shifting the knives onto the wall removes the necessity for a block beside the prep space. Completely different blade sizes can share the identical strip with out matching a set of mounted slots.
The half that makes Mohrman’s holder stand out is what disappears. Magnets, drilled holes, and mounting {hardware} all sit behind the walnut, leaving a wooden strip and three knives as the one components seen from the room.
